| |
QUALITIES
PROPERTIES
PRODUCT
RANGE |
|
home : high
speed tool bits :
Magicut
Tool Bits are made from the finest grades of steel imported
from Western Europe and Japan. These are then tested in our well equipped
laboratory for physical appearance, surface finishes, dimensions, grain
size, chemical composition, other variables and defects before further
processing - that includess a whole battery of tests, from checking
of chemical composition to microscopic tests for carbide distribution.
It is made sure that raw materials used meet with our requirements.
Our range of HSS Tool Bits
& Cut-off Blades
| High Speed Steel Tool Bits
|
Square, Round, Rectangular/ Flat |
|
High Speed Steel Cut-Off
Blades |
|
Single & Double Bevelled |
P-Shaped / T-Type |
Parting Off |
|
|
Heat-treatment is what transforms a soft, pliable piece of
steel into hard, tough and wear resistant tool bit. This is the factor
where there is no chance for compromise on quality. We have therefore
opted for furnaces manufactured under German License to ensure precise
automatic temperature control and of course very close process control.
Even then each batch is carefully tested for microstructure and each
tool for hardness in well equipped laboratory and quality control department.
After well - controlled further processing what we have is tool bit
to give you the best in every desired quality.
| Qualities Available
|
M – 2 |
| M - 35 5% Cobalt |
| M - 42 8% Cobalt |
T - 42 10% Cobalt |
ASP - 30 8.5% Cobalt |
| ASP - 60 10.5% Cobalt |
|
|
